Update of instrument firmware

For instruments with RS232 connection

To control CAMAG instrument by visionCATS, you need the corresponding firmware version. You can find the relevant firmware version and update program on the visionCATS installation disc under “Instrument Firmware”

To update the firmware of a CAMAG instrument:

  • Shut down visionCATS

  • Start the file Fwupdate.exe

../_images/fwupdate.png
  • With File/open choose the respective instrument type

../_images/serialport.png
  • With Transfer/Interface choose the respective instrument and comport

  • With Transfer/Start or burnfw start the firmware update

Warning

Do not switch of the computer or the instrument whilst the firmware is updated. Interruption during the process of firmware update can cause serious damage at your CAMAG instruments!

  • Press the reset button on your instrument keypad and observe the LCD display. During the first few seconds of the initialization the instrument display will show the actual firmware version. Check if the new firmware version is displayed

For the camera of TLC Visualizer

Note

The firmware update can only be executed from a 32- bit operational system WinXP or Win7 32-bit

Important

For Windows 7 32-bit systems, no firmware update is needed (for FW1.8.0). If using Windows 7 64-bit with a camera that has a firmware version of 1.8.0, an update will be needed.

  • For the firmware update use another Computer or Notebook with a 32-bit operating system. Do NOT use the Notebook with its build-in battery; connect the Notebook to an AC wall outlet

  • To perform a successful firmware update, the camera has to be installed properly (check device manager) on the Update- computer

  • Insert the visionCATS disc in the CD drive and search for the FW update program

  • Copy the folder “firmware” with its content to your local drive

  • Start the FwUpdate19.exe program found in the new created directory and check the current Firmware in the camera

  • The window will show the existing Firmware in the camera – in the example below, version 1.8.0 from 23/03/2005. If the existing Firmware is not version 1.9.0 or higher, proceed with the firmware update

  • Click Update button to start the update of the camera firmware.

../_images/info.jpg

Warning

Be very careful: do NOT unplug the camera or terminate the Update program during the update. This might lead to severe damage to the camera!